CRL Configuration

From Dogtag
Revision as of 20:05, 8 December 2020 by Edewata (talk | contribs) (Post-Install Configuration)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


This page describes the process to configure CRL.

Pre-Install Configuration

Enabling/Disabling CRL

CRL is enabled by default. To disable CRL specify the following parameter in pkispawn configuration file:


Configuring CRL number

The following parameter can be added into pkispawn config file:


Here 4000 is just an example. If this is set, after CA installation, the value of "crlNumber" in the db will be set to "4000" as selected instead of 1.

If there is no setting made, the current default behavior will happen. In this case the "crlNumber" will end up being set to "1" as normal.

Post-Install Configuration

See Configuring CRL.